The problem is - I heard that its official OS does not support any camera yet. So, can I install the processor SDK on this board and have all those features shown in the page's marketing video?

Hi I want to get an interrupt when a SPI reception finished. My setup is the following. I have an SPI D configured as master with loopback mode. My actual application will be configured as slave but ...

We are using the FEE driver on our application with the checksum enabled. We are noticing that sometimes, TI_Fee_WriteSync() returns okay but the actual data block was not updated. Initially we ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

The customer's PD system uses the PMP41115 solution, and there is a reference design on the TI official website But there are a few issues that need to be confirmed, 1.Should the red X line in the ...

I'm not connected the Battery yet. Trying to power on the board using external power. So, I have powered my device using Type C cable from my laptop. And I got 8.6V in SYS1 & SYS2 pins. This is clear.

Hi, in the TIDA-010210-GaN reference design, the isolation module U2 uses UCC14150DWNQ1, and this chip cannot be queried on TI's official website. Is it possible to completely replace UCC14150DWN with ...

I've been working on an application for MSPM0G3505 MCU using CCS Theia 1.5.1. My observations are that Theia is OK for tinkering with the platform and to compile the sample applications, but it's not ...

I found something strange. I can use F2800137-LP cJTAG 2PIN when use XDS110-LP. But it can't work on F280039-LP. Below is test log: (if use the xds110 which on F280039, it can work on cJTAG 2PIN) ...

Hi , I am trying to use the MSPM0C1104SDDFR SOT-8 version in my project (SEDG R&D). During development stage I also use the LP-mspm0c1104. The issue arise from the fact that we need to use the SWC,SWD ...

We are trying to bring up the CDCE6214RGE for a clock out of 100MHz 1V8 LVDS out at OUT2 and 27 MHz or 135 MHz out at OUT1. We are using 25MHz crystal input for CDCE6214. We are trying to configure ...